Mat Rollers – Service and Tutorials

Vortex Tutorial 6 - correct coning Mats that tend to cone, can be handled with a trick Put the coning side of the mat slightly higher and re-roll the mat This will adjust for effects that creates the cone

Vortex Tutorial 5 - adjusting parameters Press the button for Settings Programs can be activated and deactivated Up to 3 roll programs can be configured in the settings page All speeds can be set individually, per program If mats are not hold currently, the...

Vortex Tutorial 4 - rolling mats Put a mat on the conveyor and start the machine Once the next mat is entering the machine, the rolled mat is ejected Mats can be ejected manually by breaking the light curtain Or by pressing the ‘eject mat’ button Mats can be rolled...

Vortex Tutorial 3 – power on, start and stop   Turn on the main switch Let the PLC boot up. This takes about one minute. Release the emergency stop and reset the alarms Press the Inwatec logo or ‘home’ to get to the main screen To start or stop the machine press...

Vortex 2 Tutorial - connect power and air Remove the cover from the main switch Add a cable and fasten the lower screw Connect power: 230V single phase Connect power US/Canada: 110V single phase Put the cover back on Connect air (6 bar, 85-135...

Vortex Tutorial 1 – unpack the machine Unwrap the entire machine Remove 4 bolts which fasten the feet to the cradle A forklift can also be used for lifting up the machine Lift the machine Remove the cradle Lower the machine back to the ground Position machine at...