by Christina | Jul 15, 2021
Vortex Tutorial 6 – correct coning Mats that tend to cone, can be handled with a trick Put the coning side of the mat slightly higher and re-roll the mat This will adjust for effects that creates the... by Christina | Jul 15, 2021
Vortex Tutorial 5 – adjusting parameters Press the button for Settings Programs can be activated and deactivated Up to 3 roll programs can be configured in the settings page All speeds can be set individually, per program If mats are not hold currently, the... by Christina | Jul 15, 2021
Vortex Tutorial 4 – rolling mats Put a mat on the conveyor and start the machine Once the next mat is entering the machine, the rolled mat is ejected Mats can be ejected manually by breaking the light curtain Or by pressing the ‘eject mat’ button Mats can be... by Christina | Jul 15, 2021
Vortex Tutorial 3 – power on, start and stop Turn on the main switch Let the PLC boot up. This takes about one minute. Release the emergency stop and reset the alarms Press the Inwatec logo or ‘home’ to get to the main screen To start or stop the machine press... by Christina | Jul 15, 2021
Vortex 2 Tutorial – connect power and air Remove the cover from the main switch Add a cable and fasten the lower screw Connect power: 230V single phase Connect power US/Canada: 110V single phase Put the cover back on Connect air (6 bar, 85-135...
Recent Comments